How to make a light with a pile
A very fun and interesting experiment is the one we present below. Making a light bulb holder You may have done it once at school. When you do, you will be surprised. It's not magic, it's science. What we teach you is to make a base for the bulb to hold and work when you connect it to the battery. If you are interested look at the following article, how to make a light bulbs holder.
You will need to:- A box of matches
- A big clip
- A piece of tin paper
- 2 paper pins
- 2 pieces of cables with bare ends
- A 3.5 volt light bulb
- Scissors
one
First of all remove the inside of the box. Make a small hole in the top of it. Put a paper clip on top and insert a paper pin. Make a larger hole as seen in the drawing.
two
Then line the bottom and one side of the box tray with tin foil. Put a pin on this lined side and bend the ends back.
3
Then push the tray inside the box. Screw the bulb through the clip into the hole. The bottom of the bulb should touch the tin foil inside the box.
4
Then screw the end of a piece of wire around the pin on top of the box . Screw the other piece around the pin on one side of the box.
5
Finally, connect the ends of each cable from the bulb holder to the battery terminals to make the bulb turn on.