How to make the game of the undulating road

To make this game before you have to make the night lamp from. Once done you can start creating the game . The game consists of holding a magnet under the cardboard and driving a car along the undulating road. If it goes off the road, the bulb comes on. When this happens, go back to the exit and try again. Look at the following article, how to make the game of the undulating road.

You will need to:
  • A wide sheet of cardboard
  • A piece of tinfoil the same size as the cardboard
  • A night light without the screen
  • A magnet
  • 2 pieces of cables about 30 cm long each with bare tips
  • A 4.5 volt battery
  • 2 paper pins
  • A clip and glue
  • Paper and scissors
Steps to follow:

one

First of all cut an undulating line from one corner of the tinfoil to the other. Be careful not to break the tin foil.

two

Then spread glue on the cardboard . Put the paper on top, separate the edges and make two holes about 2 cm wide on each side at the end of the road. Squeeze the paper and fold it around the edges.

3

Then put a pin through the tinfoil on each side of a road termination. Screw a point of a wire around each pin and under the cardboard bend the tips of the pin.

4

Then connect the other ends of the two pieces of cable to the two pins in the night lamp. Make sure the bedside lamp is unplugged.

5

Fold a piece of paper into two halves and cut it into a car shape. Draw the doors and windows. Fold up a termination of a paper clip and stick the paper car in it.

6

To make races on the undulating road: make two roads in the tin paper and stick it to the cardboard as seen in the drawing.

7

Then put four pins through the cardboard one on each side of the road and two in between

8

Finally, connect the cables on one side and the pins in the middle to the two night lamps, as shown in the drawing. Make two cars with two clips . Drivers will need a magnet each.