How to clean the rims of my motorcycle

Do you want to clean your motorcycle and leave it untouched? Well, we recommend you keep reading. A clean and shiny motorcycle is not achieved by magic. It is a task that requires dedication and with a certain acquired routine, you will see how the result is worthwhile. One of the most complicated and cumbersome parts, are the tires. But with the tips that we will give you cleaning, not only will you leave your motorcycle impeccable, but you will contribute to its maintenance over time. In .com we tell you how to clean the tires of your motorcycle .

one

To start you must have on hand all the products you may need to clean your bike. There are some specific ones that combine the power and efficiency of a good degreaser with the precise care to leave it shiny. A good alternative is the products for cars, which are used for tires. They are usually very good cleaners and not very aggressive so that they end up hurting the finish of the wheels.

For the most dirty parts of the motorcycle, such as the rear wheels on a chain motorcycle, a domestic degreaser is very useful. They are effective because they clean very well, do not spoil any plastic or cause long-term damage. Even so, it is necessary to be cautious and not to use very aggressive or concentrated degreasers .

In we tell you how to clean the chain of the bike with useful tips that can help you.

two

Once you have finished washing with water, you should use a clean metal without residues since it is perfect for brake discs to remove grease and any other type of dirt. This solvent does not have to be used on the fairing parts if they are lacquered, because they can damage them.

After this step, you must use a silicone spray lubricant for the mechanical parts and those of neutral or matt plastics. You must spray a very thin layer and the result is sensational. All parts are protected, lubricated contact parts and rejuvenated rubber.

Finally, you should use a protective wax for the fairing and it is best to apply it after washing so you will improve the shine and keep the surfaces free of dirt. For shiny metal finishes you must apply a specific product for metal.

3

Now we are going to tell you some tricks to leave your bike and the tires as new. To start you should not use hot water because if you do, you would accelerate the corrosion of the metal parts. It is also not advisable to use cleaning products on the hot fairing because it can be very corrosive. Previously, you should let the motorcycle cool down or cool it with water.

The chain also you have to clean it but never with water under pressure because it would leak water and could damage it. You can use a brush and degreaser and then apply chain grease.

4

Next, let's get on with cleaning the tires, one of the worst tasks. It is best to start using water under pressure and then apply a specific cleaner that will not spoil the aluminum. Let act a few minutes on the grease or dirt to then pass a brush with which you will get an excellent result. Finish cleaning with a pressure wash.

So that the rims are impeccable, use silicone spray so that the dirt does not stick again.

In the event that you practice enduro, we recommend this other article in which we tell you how to clean an enduro bike.