How to install an alarm in your car

Thefts in cars are being very common and it is necessary to take measures to prevent thefts in vehicles. Have you recently purchased a security system for your car? We know there are many different types of alarms and installing it can be difficult. The first thing you should do is read carefully the instructions of the alarm system and then prepare the material that you will need for the installation . The installation may vary a bit depending on the make and model of the vehicle but, broadly speaking, the installation will be very similar. In this .com article you will see the steps on how to install an alarm in your car.

• Car alarm
• User's manual
• Tools

one

Prepare the car and alarm system, start by getting the wiring diagrams and designs of the car . The instruction manual that comes with the alarm system will be useful in this step.

two

Remove all car panels and covers that are specified in the alarm manual. Assemble the siren as indicated in the manual, a location such as the underside of the car's hood is commonly used.

3

Assemble the alarm module, it is a good idea to do this somewhere out of sight.

4

Place the switch following the instructions in the manual.

5

Connect the external antenna and other devices that need to be adjusted.

6

Place the LED light, if in doubt, you can go to a professional technician to make inquiries.

7

Connect the power cable of the alarm unit to the car battery . Normally, at this point, you must connect a fuse to the power cable.

8

Assemble the impact detector, this step will vary more than the rest due to the differences of the alarm units and the car models. Consult the manual carefully before installing the shock detector.

9

Use the manual to complete the wiring of the door lock, the alarm should have the current detection wire at this time.

10

Locate the starter cable in your car and install all the components to disable the starter.

eleven

Complete any remaining wiring by reading the manual. Make sure all cables are covered securely, and if there are still components that should be attached to the alarm unit, you should do so now.

• Read the entire manual before beginning the installation, it never hurts to know much about the project before you start.
• Group all the cables that go in the same place to minimize cable tangles.
• Be careful when you realize the wiring of the alarm of not leaving bare wires touching each other unless the manual says it.
• Do not try to do the work of a tool with your hands, use the right tool for the right job to avoid cuts and injuries.